Marmitek AWM2 Modo De Empleo página 10

• Install the wall switch at its original place after the MicroModule
is programmed.
Please note: due to heat generation, apply no more than one module
per flush socket / central socket!
Programming
WARNING: dO NOT FORGET TO TURN ON THE MAIN MASTER
SWITCH PRIOR TO PROGRAMMING.
Activate the setup mode.
The following steps have to be taken to start the setup procedure for
programming the MicroModule:
• Press the setup (prog.) button for at least 3 seconds (see figure
5). The LEd should stay on after releasing the setup button.
• Warning! The MicroModule will leave the setup mode if it
doesn't receive any commands within 60 seconds.
exit setup mode
• Press the setup button once shortly; The red LEd will turn off
now. You can also wait for at least 60 seconds so that the
MicroModule will exit the setup mode automatically.
10
prog.
SAIX
prog.
SAIX
© MARMiTeK
Figure 4