Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".
Instructions
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives or
ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical connection
Check whether the electrical voltage that you intend to use is
the same as that of the machine. Details are to be found on the
label on the base.
Connected Wattage
The total power consumption of this device can be up to 2200 W.
With this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: Overload!
•
If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
•
Do not use any multiple sockets, as this device is too
powerful.
Switching on/off
Switching on: Press the toggle switch downwards. The
indicator light in the switch lights up.
Switching off: Press the toggle switch upwards. The indicator
light in the switch goes off.
Use
NOTE:
•
Always use fresh water.
•
Do not consume the water if it has been in the kettle for
more than one hour.
•
Also do not constantly reheat cooled water.
•
Always pour out stagnant water.
30
1. Place the machine on a flat surface.
2. Open the water kettle using the recessed handle in the lid.
3. Then fill in the water (max 1.7 Litre). You can read the filling
level on the water level indicator of the kettle.
4. Close the lid until it audibly locks into place.
5. Place the kettle flush on the base.
6. Only connect the machine to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch. The control
lamp in the switch will light up.
Pausing/ terminating operation
There are two options to interrupt the boiling process or to
terminate it:
•
The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
•
Set the switch to the "O" position to pause or terminate the
boiling process.
WARNING:
•
Do not remove the appliance from the base without shut-
ting it off first. As long as the switch is in the "I" position,
the kettle will stay turned on.
•
Always shut off the appliance before removing it from the
base! Also ensure that it is turned off when you set it back
onto the base!
WARNING: Danger of scalding!
•
When pouring the water out, keep the lid closed.
•
During operation the housing becomes hot. Do not touch
it and allow the device to cool down before storing it
away.
•
Disconnect the power cord.
•
Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.
Publicidad
