Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
•
Stretch Skin for Better Skin Contact – the contours of the skin may make it difficult for the skin contact sensors to
be fully depressed in certain areas. You may find it easier to try and wrap your upper lip over your teeth or use your
tongue to stretch your cheeks for better skin contact.
POST TREATMENT CARE
•
After treatment, you may experience slight redness or a warm sensation on your skin. This is normal and will disap-
pear over time. To avoid irritation to your skin after a treatment, take the following precautions:
•
Avoid sun exposure for 24 hours after a treatment. Protect the skin with SPF 30 for 2 weeks after each treatment.
•
Do not prolong sun exposure such as sunbathing, using a tanning bed, or self-tan for at least 2 weeks after the last
treatment.
•
After treatment, keep the area clean and dry and drink plenty of water to keep skin hydrated.
•
Do not take hot baths, showers, or use steam rooms and saunas until any redness or skin sensitivity has returned to
normal.
•
Do not depilate (waxing, plucking, threading or creams) during the treatment – shaving is acceptable as long as you
avoid shaving 24 hours after each treatment.
•
Do not use bleaching creams or perfumed products for 24 hours after treatment.
300,000 FLASH BULB
•
This i-LIGHT product includes a spare bulb.
•
Each bulb will deliver 150,000 flashes during its lifetime, and is guaranteed to last for the entire guarantee period as
communicated on the guarantee card supplied with this product.
•
If you do need to replace the bulb, please refer to the separate step-by-step guide sheet. Additional bulbs are avail-
able from your local Remington service centre.
•
Signs that the bulb needs replacing:
•
Bulb Status Indicator is illuminated yellow: 150 Flashes remain in the bulb.
•
Bulb status indicator is flashing yellow: Bulb is empty.
CLEANING YOUR i-LIGHT DEVICE
F CAUTION Before cleaning your i-LIGHT, make sure that the device is switched OFF and the power cord is
disconnected from the device.
Regular cleaning helps to ensure optimal results and a long life for the i-LIGHT device.
•
To clean the Flash Window, use only the lint-free cloth included with your i-LIGHT device. Take care not to scratch or
chip the Flash Window. Scratches and chips can reduce the effectiveness of the unit.
•
For stubborn stains on the flash window, dampen a cotton swab with surgical spirit or rubbing alcohol, apply to the
flash window and clean gently with the lint-free cloth provided.
F WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch the filter glass or the
metallic surface inside the Treatment Head.
F CAUTION: The i-LIGHT is a high voltage device. Never immerse in water. Never clean the unit or any of its parts
under a tap or in a dishwasher.
Storage
Switch off the unit, unplug and allow to cool for 10 minutes before storage.
TROUBLESHOOTING
•
Always read these instructions fully before using i-LIGHT.
•
Refer to this troubleshooting guide if you experience any problems with i-LIGHT, as this section addresses the most
common problems you could encounter with i-LIGHT. If you have followed the instructions in this section and con-
tinue to experience problems, please contact the Remington® Service Centre for further assistance.
10
Publicidad
