Automatic Operation (Auto Changeover); Timer Operation - Toshiba MMK-AP0073H Manual Del Propietário

SMMS High-Wall Type
Automatic operation
(auto changeover)
This function is available only for use in
combination with a heat recovery model outdoor
unit. If this function is used with another model of
outdoor unit, "A" (Auto) appears on the remote
controller but the automatic operation is disabled.
Start
PRESET
TEMP
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select A.
3
Temperature button (
Set the desired temperature.
4
Fan speed button (FAN)
Select one of LOW
+
MED , MED
HIGH .
• The OPERATION lamp (green) on the
display panel of the indoor unit lights.
The operating mode is selected in accordance
with the room temperature and operation starts
after approximately 3 minutes.
• If the "A" mode is uncomfortable, you can select
the desired conditions manually.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
3
4
FAN
1
MODE
2
)
)
TEMP
+
, LOW ,
,
)
– 12 –

Timer operation

Use the wired remote controller for timer setting if it
is also in use.
ON timer and OFF timer
PRESET
TEMP
QUIET
SWING FIX Hi-POWER
TIMER
ON OFF
SLEEP
CHK FILTER
Setting TIMER
1
ON/OFF TIMER button (
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes
along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the time in
ten minute steps.
Pressing the TIMER button continually changes the
time in one hour step.
2
SET button
SET
Press the SET button to set the timer.
SET
The timer time is indicated and the timer starts.
Cancelling TIMER
3
CLR button
CLR
Press the CLR button to cancel the timer setting.
CLR
CAUTION
• When you select the timer operation, the
remote controller automatically transmits the
timer signal to the indoor unit at the specified
time. Therefore, keep the remote controller in a
location where it can transmit the signal to the
indoor unit properly. Otherwise, the time lag of
up to 15minutes will occur.
• If you do not press the SET
seconds after setting the time, the setting will
be cancelled.
Owner's Manual
FAN
MODE
COMFORT
SLEEP
1
3
CLR
2
SET
CLOCK
or )
OFF
ON
button within 30
SET
EN
12-EN