Ruby DN 12 EN Manual De Instrucciones página 11

When Bucket Full Lamp Is On
machine and it should be emptied. When the empty tank is replaced properly into the ma- chine, the
machine will start up and run normally.
Remove the water in the water tank with two hands.
Defrost
When the machine is operated at low temperatures (less than 12ºC ) the surface of the evaporator
may accumulate a layer of frost which would reduce the efficiency of the machine. When this
happens the machine will go into periodic defrost mode. The defrost symbol
will come on. The machine wills operate in temperatures down to 5°C. The time taken to defrost
may vary. If the machine freezes up, it should be turned off at the power supply and re- started. If
the room temperature remains below 5°C the machine should be switched off.
Installation of Wheels
1. Take the wheels out of the water tank.
2. Position the dehumidifier on its side.
3. Locate the arrow on the bottom of dehumidifier and inser the wheel
according to the arrow direction.
4. Slide the wheel in as far as it will go. The caster will snap into place.
5. Repeat steps 3 to 4 for the others wheels.
6. Place the unit upright, wait 4 hours before use.
Continuous Drainage Under Good Condition
The function of continuous drainage can be started in following steps when there is a good
condition of drainage near by the unit.
1) Prepare PVC hose to drain out water (The hose sold in market)
2) Take out stopper from the drainage outlet.
3) Remove the flat pad inside the stopper.
4) Make the drainage pipe go through the ring of the stopper.
5) Place the bucket on its original location.
The Proper Way To Place The Water Drainage PVC Hose.
DN 12/16-EN
When the water tank is full the machine
will stop and the "Bucket Full" light will
illuminate. The water tank should be
carefully removed from the machine by
sliding it outwards from the front of the
on the LCD display
11