EGO SNT2110-FC Manual De Funcionamiento página 28

REPLACING THE RUBBER PADDLE
WARNING:
off the bail switch and remove the
battery pack(s) before performing any
maintenance task on your snow blower
1. Wear gloves. Manually rotate the
steel auger to the appropriate
position for easy rubber paddle
disassembly as Fig. 26 shown.
2. Use a flat head screwdriver(not included) to thoroughly loosen the two bolts on
one side and remove the two bolts and two nuts to take away the rubber paddle
from the steel auger.
3. Disassemble the other rubber paddle on the other side in the same way.
4. Replace them with the new rubber paddles and securely tighten them.
REPLACING THE DRIVE BELT
If the drive belt becomes worn, oil-
soaked, excessively cracked, frayed, or
otherwise damaged, replace the belt.
WARNING:
off the bail switch and remove the
battery pack(s) before performing any
maintenance task on your snow blower.
1. Use a T20 Torx screwdriver (not included) to remove the drive belt cover by
removing the 8 Torx screws as shown in Fig. 27.
28
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2110/SNT2110-FC
Make sure to turn
Make sure to turn
26
Steel Auger Bolt
Rubber Paddle
27
Torx Screw
Drive Belt
Cover
Nut