Publicidad
Idiomas disponibles
Idiomas disponibles
Retainer Pin
Retulator Cap
4.
Remove the retainer pin that is currently positioned for use with Natural Gas. (Refer to Figure 15.)
5.
Turn the retainer pin upside down and re-install into regulator cap. (Refer to Figure 15.)
6.
Screw the regulator cap back into the regulator and reattach the regulator to the nipple and flare union.
(Refer to Figure 15.)
Converting Surface Hob Burners (Natural Gas to LP Gas)
1.
Remove the burner grates, burner caps and burner heads.
2.
Using a 7 mm nut driver, remove the burner orifices.
Triple Ring Burner - 5 Nozzles
3.
Install the proper orifices in replace of the ones that were removed.
4.
Re-install the burner bases, heads and top grates. Make sure the burner caps are properly seated on the
burner heads.
NOTE: The triple burner has only two injectors, one injector mounted in the center and one mounted below
the cover plate. To access the second injector, remove the two screws and the cover plate.
IMPORTANT: Once the conversion has been completed and has passed testing, fill out the conversion sticker
and include your name, organization and the date conversion is made. Apply the sticker near the cooktop gas inlet
opening to alert others in the future that this appliance has been converted. If converting back to Natural Gas,
remove the sticker so others know that the appliance is set to use its original gas.
Regulator
Nozzles
Auxiliary Burner - 1 Nozzle
13
Figure 15
Figure 16
Publicidad
