Publicidad
Idiomas disponibles
Idiomas disponibles
SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6 T).
The SWING Display (Fig. 7 c) will light.
Each time the SWING button is pressed, the swing operation will change in the
following order.
Up/down swing operation
Swing operation stops
To stop SWING Operation
Press the SWING button and select STOP.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
G Up/down swing: Swing operation begins using the
following range according to the current airflow direc-
tion.
Airflow direction is 1–4 (for cooling, dry).
With the upper airflow-direction louver in the
horizontal position, the lower airflow-direction
louver moves (swings) to direct airflow to a wide
area.
Airflow direction is 3–6 (for heating).
With the airflow-direction louvers set for down-
ward or straight down airflow, airflow is directly
mainly at the floor.
COIL DRY OPERATION
The Indoor unit can be dried by pressing the COIL DRY button on the Remote Control Unit so as to avoid going moldy and
restrain the breed of bacterium.
The COIL DRY Operation will operate for 20 minutes after pressing the COIL DRY button and it will stop automatically.
To select COIL DRY Operation
Press the COIL DRY button (Fig. 6 L) during operation or when
it stops.
The COIL DRY Display (Fig. 7 a) will light. Then it will disappear after 20 minutes.
To cancel COIL DRY Operation
Press the START/STOP button (Fig. 6 Q) during COIL DRY
Operation.
The COIL DRY Display (Fig. 7 a) will go out . Then the operation stops.
About COIL DRY Operation
G Press the COIL DRY button again during COIL DRY Operation, COIL DRY Opera-
tion can be reset.
G The COIL DRY Operation cannot get rid of the existed mould or bacterium, and it
has no sterilization effect either.
Left/right swing operation
Up/down/left/right swing operation
G Left/right swing: The airflow-direction louvers move
G Up/down/left/right swing: The airflow-direction louvers
G The SWING operation may stop temporarily when the
G If the SET button(Vertical) is pressed during the up/
(swing) in the left/right airflow direction.
move (swing) in both the up/down and left/right airflow
directions.
air conditioner's fan is not operating, or when operating
at very low speeds.
down swing operation, the up/down swing operation
will stop and if the SET button(Horizontal) is pressed
during the left/right swing operation, the left/right
swing operation will stop.
En-10
Publicidad
