Black and Decker BDECS200 Manual De Instrucciones página 9

I
5
10
11
15
GENERAL CUTS (IMPORTANT:
READ SAFETY WARNINGS AND
INSTRUCTIONS. )
GUARD AGAINST KICKBACK
With unit unplugged, follow all assembly,
adjustment and set up instructions.
Make sure lower guard operates. Select
the proper blade for the material to be cut.
• Measure and mark work for cutting.
• Support and secure work properly (See
Safety Rules and Instructions).
• Use appropriate and required safety
equipment (See Safety Rules).
• Secure and maintain work area (See
Safety Rules).
• With plug inserted and guard closed,
make sure switch turns saw on and off.
WARNING:
It is important to support
the work properly and to hold the saw
firmly to prevent loss of control which
could cause personal injury. Figure C
illustrates proper hand position.
Operation
OPERATION
SWITCH
• To operate the tool, depress the trigger
switch (1). The tool will continue to run
as long as the trigger is depressed.
• To turn the tool off, release the trigger
switch (1). There is no provision for
locking the tool on, and the switch should
never be locked on by any other means.
LASER LINE (BDECS300 ONLY)
WARNING:
LASER RADIATION.
Never aim the beam at a workpiece
with a reflective surface. Bright shiny
reflective sheet steel or similar reflective
surfaces are not recommended for laser
use. Reflective surfaces could direct the
beam back toward the operator.
DANGER:
LASER RADIATION.
AVOID DIRECT EYE EXPOSURE. Do
not stare into the laser light source.
Never aim light at another person or
object other than the workpiece. Laser
light can damage your eyes.
WARNING:
glasses to enhance the laser light.
Tinted glasses will reduce overall vision
for the application and interfere with the
normal operation of the tool.
TO USE THE LASER LINE
• Mark the line that you intend to cut on
the workpiece.
• Adjust the depth and angle of cut as
required.
• Depress the saw trigger switch (1) to
project the laser beam (Figure J). Allow
the blade to reach maximum speed.
• Place the saw shoe on the workpiece.
Align the laser line with the mark on
the workpiece and slowly push the saw
forward, keeping the laser line on the mark.
J
ADJUSTING THE LASER LINE
• Before making a cut, make sure the
laser line (8) is accurate. The laser
should line up in the right notch (17) of
the shoe. When the saw is beveled, the
laser should line up in the left notch (18)
as shown in the inset of Figure K.
• If the laser needs to be adjusted, use
a screwdriver to rotate the screw (19)
back and forth until the laser lines up
properly (Figure K).
K
CUTTING OPERATIONS
WARNING:
serious personal injury,always hold the
tool with both hands.
• After switching the tool on, allow the
blade to come up to full speed before
9
DO NOT use tinted
19
18 17
To reduce the risk of