Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fig. G
6
Actuating Tool (Fig. A)
WARNING: To reduce the risk of injury, ALWAYS
wear proper eye ANSI Z87.1 (CAN/CSA Z94.3) and
hearing protection ANSI S12.6 (S3.19) when operating
this tool.
WARNING: Keep fingers AWAY from the trigger when
not driving fasteners to avoid accidental actuation.
Never carry a tool with finger on the trigger. The tool
will drive a fastener if the contact trip is bumped
while the trigger is depressed. Serious injury could
result if the trip accidentally contacted someone or
something, causing the tool to cycle.
Contact Actuation Trigger -
The contact trigger
is intended for rapid fastening on flat,
1
stationary surfaces.
Using the contact trigger, two methods are available: place
actuation and contact actuation.
To Operate the Tool Using the PlACE ACTUATiOn
Method
1. Depress the contact trip
4
2. Pull the trigger to drive the fastener.
3. Allow the tool to recoil off the work surface
To Operate the Tool Using the COnTACT ACTUATiOn
Method
1. Pull the trigger.
2. Depress the contact trip
4
long as the trigger is pulled, the tool will drive a fastener
every time the contact trip is depressed. This allows the
user to rapidly drive multiple fastener in sequence.
single sequential Trigger -
WARNING: Allow the tool to recoil off the work
surface after actuation. If the contact trip remains
depressed, a nail will be driven each time the trigger is
released and pulled, which could result in accidental
actuation, possibly causing injury.
The sequential actuation trigger's intended use is for
intermittent fastening where accurate fastener placement
is desired.
6
3
(Fig. A)
against the work surface.
against the work surface. As
To operate the tool in single sequential
actuation mode
1. Depress the contact trip
4
work surface.
2. Pull the trigger.
3. Allow the tool to recoil from the work surface.
Adjusting Depth (Fig. H)
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
•
Disconnect air supply.
•
Avoid contact with trigger during adjustments.
The depth that the fastener is driven can be adjusted using
the depth adjustment next to the trigger of the tool. The
depth of drive is factory adjusted to a nominal setting. Test
drive a fastener and check depth. If a change is desired:
1. To drive the nail shallower, rotate the depth adjustment
wheel
to the right.
5
2. To drive a nail deeper, rotate the depth adjustment
wheel
5
to the left.
The adjustment wheel has detents every 1/4 turn. Test drive
another fastener and check depth. Repeat as necessary to
achieve desired results. The amount of air pressure
required will vary depending on the size of the fastener
and the material being fastened. Experiment with the air
pressure setting to determine the lowest setting that will
consistently perform the job at hand. Air pressure in excess
of that required can cause premature wear and/or damage
to the tool.
Fig. H
5
Shingle Guide (Fig. I, J)
Adjust shingle guide
1. Loosen the screw
with a hex wrench and slide the
13
shingle guide
to the desired position.
7
2. Retighten the screw with firmly.
firmly against the
Publicidad
