Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
INSTALLING THE SINK
NOTE:
Install the faucet according to the manufacturers instructions before
completing this step. Install the strainer accordingly to the instructions on
page 11 before completing this step.
- Attach the topmount clips (E) to the clip brackets until they
snap in place .
- Rotate the clips so that they are parallel with the sink bowls
on all sides .
- Using a screw driver, extend the clips at least 75% of the way .
- Apply silicone sealant (not included) around the underside of
the flange of the sink (A) on all four sides.
- Carefully lower the sink (A) into the counter, ensuring it is
centered and parallel with the front of the counter .
- Rotate the clips into position and tighten them down to the
counter progressively (see tightening sequence) until the sink
flange is flush with the counter. Do not over-tighten the clips
as that can damage the brackets . Check the alignment as you
tighten so that the sink (A) is centered and parallel .
NOTE:
If the flange is not flush with the counter, use a heavy weight or clamp
from above to press the flange down until the sealant sets.
- When finished, wipe away any excess sealant and allow it to
set before proceeding with the rest of the installation .
QK23R
Clip
Bracket
E
A
Silicone
Sealant
E
Counter
2
10
12
Location
3
of clip
Tightening sequence for clips
10
A
Clip
Bracket
A
8
6
4
11
9
5
7
1
Publicidad
