Publicidad
DIN-Rail Mounting
1.
Attach the DIN rail kit onto the switch using the bracket
and screws in the accessory kit.
2.
Hook the unit over the DIN rail.
3.
Push the bottom of the unit towards the DIN rail until it
snaps into place.
2
3
Ver. 1.00(WW) 2018/06/06 GP801010X-000
Wall Mounting
(unit: mm)
1.
Attach the wall mounting kit onto the switch using the
mounting plates and M4 screws in the accessory kit.
5-Port Model
8-Port Model
Connecting to Ground
The switch must be properly grounded for optimum system
performance.
5-Port Model
8-Port Model
Connecting to Ethernet Interfaces
(RJ-45)
Connecting the Ethernet interface via RJ-45:
To connect to a PC, use a straight-through or a
cross-over Ethernet cable,
To connect the switch to an Ethernet device, use UTP
(Unshielded Twisted Pair) or STP (Shielded Twisted
.
Pair) Ethernet cables
The pin assignment of the RJ-45 connector is shown in the
following figure and table.
Pin
1,2
3,6
Assignment
T/Rx+,T/Rx-
R/Tx+,R/Tx-
2
Publicidad
