Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
INSTALLING THE SINK
NOTE:
Install the strainer according to instructions on page 9 before completing this step.
- Press fit the threaded anchor inserts (E) into the holes drilled into the underside of the countertop. Use a bolt to make this process
easier if required .
- Loosely thread the undermount bolts and clips into the threaded anchor inserts and align them parallel to the sink flange outline
so they do not interfere with the placement of the sink .
- Place a small bead of silicone sealant (not included) around the outer top perimeter of the sink flange as shown below.
- Carefully place the sink (A) into its location under the counter, lining up the sink with the sink flange outline.
- Carefully rotate the clamps of the undermount clips (E) over the sink flange and gently tighten the bolts (see tightening sequence)
to fasten the sink. Recheck the alignment visually from above and make final adjustments if necessary, then tighten all the bolts.
- Wipe away any excess silicone and, for best results, allow the bond to rest undisturbed for 8 hours or overnight .
- Install the counter, faucet, and all other plumbing as per manufacturer's instructions .
E
SUPPLY LINES (NOT INCLUDED)
The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately .
Follow the supply line manufacturer's instructions for proper installation .
QK92R
A
Silicone
Sealant
Tightening sequence for clips
8
6
2
4
9
7
10
8
3
5
1
Publicidad
