WIKA A-10 Manual De Instrucciones página 6

3. Safety / 4. Mounting
Before mounting and commissioning the instrument, ensure you read the operating instructions!
EN
DC voltage
Do not dispose of with household waste. Ensure a proper disposal in accordance with national
regulations.
4. Mounting
4.1 Mechanical mounting
Only use the pressure transmitter if it is in perfect condition with respect to safety.
Prior to commissioning, the pressure transmitter must be subjected to a visual inspection.
Leaking liquid is indicative of damage.
■
Obvious damage must be reported immediately.
■
For information on tapped holes and welding sockets, see technical information IN 00.14 at www.wika.com.
4.2 Electrical mounting
Voltage supply
→ For auxiliary power, see product label
→ For further details on electrical mounting, see IN 00.50
For instruments without North American certification:
This equipment is intended for operation with low voltages, which are separated from the AC 230 V (50 Hz) mains
voltage or voltages greater than AC 50 V or DC 120 V for dry environments. A connection to an SELV circuit is
recommended, or alternatively to circuits with a different protective measure in accordance with IEC 60364-4-41
installation standard.
6
WIKA operating instructions pressure transmitter, model A-10