Publicidad
Idiomas disponibles
Idiomas disponibles
3. UNIT INSTALLATION
3.1 Installation Instruction
①
This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot
bear the load equal to two times of the total weight of the heater filled fully with water, it is
then necessary to install a special support.
Incase of hollow bricks wall, ensure to fill it with cement concrete completely.
After selecting a proper location, determine the positions of the two install holes used for
②
expansion bolts with hook (determined according to the specification of the product you
select). Make two holes in the wall with the corresponding depth by using a chopping bit with
the size matching the expansion bolts attached with the machine, insert the screws, make
the hook upwards, tighten the nuts to fix firmly, and then hang the electric water heater on it
(see Fig.2).
Install the supply socket in the wall. The requirements for the socket are as follows: 250V/10A,
③
single phase, three electrodes. It is recommended to placed the socket on the right above
the heater. The height of the socket to the ground shall not be less than 1.8m (see Fig.3). If
there is fault on power cable, it should be replaced by the manufacturers, agencies or qualified
person who is able to do this so as to ensure the safety.
L (Brown)
E (Yellow/Green)
N (Blue)
If the bathroom is too small, the heater can be installed at another place without sun-scorched and
④
rain-drenched. However, in order to reduce the pipeline heat losses, the installation position of
the heater shall be closed to the location shall be as near as possible to the heater.
3.2 Pipelines Connection
The dimension of each pipe part is G1/2" ; The massive pressure of inlet should use Pa as
①
the unit; The minimum pressure of inlet should use Pa as the unit.
②
Connection of pressure relief valve with the heater on the inlet of the water heater.
In order to avoid leakage when connecting the pipelines, the rubber seal gaskets provided
③
with the heater must be added at the end of the threads to ensure leak proof joints (see
Fig.4).
≥1.8m
Ground
5
Expansion bolt
(with hook)
(Fig.2)
(Fig.3)
Publicidad
