Flex LDE 15-10 125 R Instrucciones De Funcionamiento Originales página 20

NOTE
If required, the handle can be moved
to the other side of the electric power tool.
Adjusting the guard (LD 15-10 125 R /
LDE 15-10 125 R)
NOTE
The brush ring should protrude over the
sanding pad by approx. 0–1 mm.
To compensate for wear on the diamond
sanding pad, the height of the guard can
be adjusted.
Loosen clamping lever on guard hood.

Set the guard hood to the required

height.
Tighten the clamping lever.

Switching the electric power tool on
and off
Brief operation without engaged switch
rocker
Push the switch rocker forwards and hold

in position.
To switch off the power tool, release the

switch rocker.
20
LD 15-10 125 R / LD 15-10 125 / LDE 15-10 125 R
Continuous operation with engaged
switch rocker
Push the switch rocker forwards and

engage by pressing the front end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Switch off the machine:
To switch off the power tool, release the

switch rocker by pressing the rear end.
Preselecting the speed
(LDE 15-10 125 R)
To set the operating speed, move the dial

to the required value.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.