Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL THE METAL HOOK
Before install the metal hook, follow the procedure as shown below.
1. Align the holes of metal hook to the tool housing.
2. Use screws to fasten the metal hook to the tool housing.
NOTE
Always check the direction of the rotation before use.
1. After continuous use, allow the impact wrench to sit idle for 15 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
work is started again immediately after the battery has been changed, eventually
resulting in burned-out.
2. Place the point of the bolt in the socket. Keep the tool pointed straight at the bolt.
3. Apply forward pressure to the tool to prevent the socket from slipping off the bolt.
4. To start, turn impact wrench/driver on. Always check torque with a torque wrench.
The fastening torque can be affected by many factors including the following:
Voltage: Low voltage due to a nearly discharged battery will reduce the fastening
torque.
Socket Size: Failure to use the correct socket size will cause a reduction in fastening
torque.
Variable Speed Trigger Switch: Operating the tool at a reduced speed will reduce the
fastening torque.
Bolt Size: Larger bolt diameters generally require higher fastening torque. Fastening
torque will also vary according to length, grade, and torque coefficient.
1English1
Align Hook to Hole
OPERATION
English
Fasten with Screw
-10
Publicidad
