HQ-Power HQLB10003 Manual Del Usuario página 9

6.2 Menu
mode
DMX mode
auto
sound
speed
sensitivity
edit colour
colour
temperature
dimming
silent scene
slave
6.3 Stand-Alone Mode
The device starts running in stand-alone mode after connection to the mains. This mode
allows you to use the device without controller.
6.4 Master/Slave Mode

The master/slave mode allows for connecting several devices to a single master device
in a daisy chain.

All slave devices will then work synchronously with the master device.

Configure all slave units before connecting the master unit to the daisy chain.
6.5 DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.

All DMX-controlled devices need a digital start address so that the correct device
responds to the signals. This digital start address is the channel number from which
the device starts to "listen" to the DMX controller. The same starting address can be
used for a whole group of devices or an individual address can be set for every
device.

When all devices have the same address, all the units will "listen" to the control
signal on one particular channel. In other words: changing the settings of one
channel will affect all devices simultaneously. If you set individual addresses, each
device will "listen" to a separate channel number. Changing the settings of one
channel will only affect the device in question.
DMX Channel Values
Refer to page 3 of this manual.
V. 02 – 16/02/2018
HQLB10003
programming
6CH
4CH
Addr
2CH
1CH
Auto Au1-3
Soun So1-3
SPEE SP1-9
SEns SE1-9
U000-255
Colo
C000-255
3200
4300
tEMP
5600
6500
dIMM dI1-9
SILE on/oFF
SLAV slave
9
description
d001-d512
auto programme 1-3
sound programme 1-3
adjustable speed
adjustable microphone sensitivity
warm white, 0-100 %
cold white, 0-100 %
3200 K
4300 K
5600 K
6500 K
adjustable dimming value
closed/open light when no music
in sound mode
slave mode
©Velleman nv