Publicidad
Idiomas disponibles
Idiomas disponibles
I
NITIAL SETTING
LANGUAGE
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to "Language Selection" on page 14.)
Auto Channel Scan
If you switch wires (e.g., between antenna and CATV) or if you move the
unit to a different area after the initial setting, or if you restore the DTV
channel you deleted, you will need to perform auto channel scan.
Before you begin:
Make sure if the unit is connected to antenna or cables.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K / L] to select "CHANNEL" , then press
[ENTER].
or
3
Use [Cursor K / L] to select "Autoscan", then press
[ENTER].
or
Use [Cursor K / L] to select an appropriate option, then
press [ENTER].
or
•
When aerial antenna is connected, select "Air".
•
When connected to CATV, select "Cable".
•
Scanning and memorizing of channels start
automatically.
•
When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
14
EN
All manuals and user guides at all-guides.com
Channel
Channel
Autoscan
Channel List
Manual Register
Antenna
Autoscan
Autoscan
Back
Autoscan will rescan all channels.
This may take a while to complete.
Air
Select the destination of "ANT.IN" jack.
Cable
Cable
1 hour
Air
Cable
Or
ANT.IN
Now the system is scanning for channels, please wait.
72%
Analog channels
10ch
Digital channels
6ch
SETUP
Exit
Note:
• After setting "Auto Channel Scan", using [CH. K / L] on the
remote control skips unavailable programs automatically.
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER] or [SETUP] during auto channel
scan, the setting will be canceled.
• Channel settings will be saved even if the power fails.
• If you need the English menus instead of the Spanish or
French menus you are having, press [SETUP]. Use
[Cursor K / L] to select "IDIOMA" or "LANGUE", then press
[ENTER]. Use [Cursor K / L] to select "English", then press
[ENTER]. Press [SETUP] to exit the main menu.
• With regard only to the digital channel, even after the
scanning is completed if you unplug the AC power cord
before turning off the unit by pressing [POWER], the
channel setting may be lost.
Language Selection
You can choose English, Spanish or French as your on-screen language.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K / L] to select "LANGUAGE", then press
[ENTER].
or
3
Use [Cursor K / L] to select "English", "Español" or
"Français", then press [ENTER].
or
4
Press [SETUP] to exit.
Language
Language
Select the language for setup display.
English
Elija el idioma de ajuste.
Español
Français
Sélectionner langue écran config.
Publicidad
