Colour Code Connecting Wires - Marmitek TMD4 Modo De Empleo

• Can react to one or more group commands (ALL LIGHTS ON,
ALL UNITS OFF). These functions are switched off standard.
• Address programmable via electric mains with the help of any
Marmitek X-10 remote control (for instance Marmitek)
• EasyControl8 remote control with Marmitek X-10 TM13
Transceiver).
• Improved S/R ratio for reliable X-10 communication.
• Power/Status/Programmer LED.

COLOUR CODE CONNECTING WIRES

Switch input 1:
Switch input 2:
Switch input 3:
Switch input 4:
Switches common:
WARNING : ON THE CONNECTING WIRES IT SAYS : DANGEROUS,
230V TENSION. NEVER CONNECT THE SWITCH WHEN THE
MODULE IS LIVE. SWITCH OFF THE MAIN SWITCH. NOTE: THE BLUE
WIRE (COMMON) IS CONNECTED IN THE MODULE TO THE ZERO
TERMINAL (N).
Description of the wires of the Marmitek TMD4
MicroModule.
Brown: Input 1, Programmed address (standard A1). When the
brown wire of the MicroModule is connected to the blue wire of the
MicroModule for a short time (shorter than 0.5 second) then an
ON/OFF signal is sent. Was the status in the module ON, an OFF
command is sent. Was the status in the module OFF, an ON
command is sent.
When the brown wire of the MicroModule is connected to the blue
wire longer than 0.5 second, a BRIGHT or a DIM command is sent.
When the last sent command was DIM then a BRIGHT command is
sent. When the last sent command was BRIGHT a DIM command is
sent.
8
Brown
Red
Orange
Yellow
Blue
© MARMITEK