Garland CRUMMER 1220 QGW Manual De Instrucciones página 39

D. Place the accelerator lever in the maximum
position .
E1.Move the key to the START position.
E2.Or pull the starter handle until the engine starts
and gradually move the air lever to the OPEN position
(normal working position). Put the throttle lever in the
down position and allow the engine to warm up for 1
minute before starting work.
Normal working
position
Turtle = Minimum
Hare = Maximum
6.4.2.2. ELECTRIC AND MANUAL HOT START
Follow steps A and B of cold start. Move the throttle
lever to the middle position, then turn the key to the
START position or pull the starter grip until it starts.
6.4.2.3. ENGINE STOP
Turn the engine switch with the key in the OFF
position. If the shredder is to be stored, place the fuel
bypass lever in the OFF position.
7. MACHINE USAGE
Make sure the plastic cover over the hopper is closed
when the shredder is running. Splinter can jump and
be dangerous.
Do not put your face or hands in the hopper.
Keep your face and body away from the hopper.
Not stand in front of the discharge chute and not
try to open while the machine is operating.
Wear glasses and gloves.
Do not clean the material with the engine running.
Throttle level
Stop the engine before clean up. Use shovel, rake or
other tool extensible. Never your hands and feet.
Before start operating, check the wind direction to
not work face to the gases.
Switch off the machine before refuel.
To move the machine pick it fi rmly grips of both
hands,turn the wheel with your foot, lift the
machine, pay attention to the central bar of the
machine and walk slowly.
7.1. HOW TO WORK WITH THIS MACHINE
7.1.1. CUTTING LOGS
The long logs such as sunfl owers, corn and tree
branches are introduced by cutting the side tube
(nozzle) to be cut with the blade rotating.
Some logs will be pushed into the blades with the
following logs, never use your hands.
The last log can be pushed with a stick of wood
ever with their own hands.
39/148
English