Publicidad
Idiomas disponibles
Idiomas disponibles
Section
Audio Adjustments
12
! If you set the slope to 0 dB/oct. (Pass), the
audio signal bypasses the filter, so the filter
does not have an effect.
Phase adjustment
When the cross-over point value for filters on
both sides is set to –12 dB/oct., the phase is
reversed 180 degrees at the filter cut-off fre-
quency. In this case, reversing the phase as-
sures improved sound continuity.
Normal phase
Muting the speaker unit (filter)
You can mute each speaker unit (filter). When
a speaker unit (filter) is muted, no sound is
outputted from that speaker.
! If you mute the selected speaker unit (fil-
ter), MUTE blinks and no adjustments are
possible.
! Even if any speaker unit (filter) is muted,
you can adjust the parameters for other
speaker units (filters).
1
Use MULTI-CONTROL to select NW 1.
NW 1 appears in the display.
2
Push MULTI-CONTROL left or right to
select the speaker unit (filter) to be ad-
justed.
Each time MULTI-CONTROL is pushed left or
right, the speaker unit (filter) is selected in the
following order:
Low LPF (low-range speaker LPF)—Mid HPF
(middle-range speaker HPF)—Mid LPF (mid-
dle-range speaker LPF)—HighHPF (high-range
speaker HPF)
60
En
All manuals and user guides at all-guides.com
Reverse phase
Crossover point
3
Push and hold MULTI-CONTROL down
to mute the selected speaker unit (filter).
MUTE blinks in the display.
# To cancel the muting, push MULTI-CONTROL
up.
Adjusting network
1
Use MULTI-CONTROL to select NW 1.
NW 1 appears in the display.
2
Push MULTI-CONTROL left or right to
select the speaker unit (filter) to be ad-
justed.
Each time MULTI-CONTROL is pushed left or
right, the speaker unit (filter) is selected in the
following order:
Low LPF (low-range speaker LPF)—Mid HPF
(middle-range speaker HPF)—Mid LPF (mid-
dle-range speaker LPF)—HighHPF (high-range
speaker HPF)
3
Turn MULTI-CONTROL to select NW 2.
NW 2 appears in the display.
4
Push MULTI-CONTROL left or right to
select the cut-off frequency (crossover fre-
quency) of the selected speaker unit (fil-
ter).
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies (crossover frequen-
cies) are selected in the following order:
Low LPF: 25—31.5—40—50—63—80—100
—125—160—200—250 (Hz)
Mid HPF: 25—31.5—40—50—63—80—100
—125—160—200—250 (Hz)
Mid LPF: 1.25k—1.6k—2k—2.5k—3.15k—
4k—5k—6.3k—8k—10k—12.5k (Hz)
HighHPF: 1.25k—1.6k—2k—2.5k—3.15k—
4k—5k—6.3k—8k—10k—12.5k (Hz)
Publicidad
