Philips AVENT SCD498 Manual Del Usuario página 8

EngliSh
8
parent unit
Battery operation
The parent unit runs on two rechargeable 1.2V AAA NiMh batteries that are supplied with the
appliance.
Make sure your hands and the unit are dry when you insert the batteries.
1 Slide the battery compartment lid downwards to remove it (Fig. 6).
 Insert the two rechargeable batteries (Fig. 7).
Make sure the + and – poles of the batteries point in the right direction.
,
 Slide the battery compartment lid back onto the back of the parent unit until it locks into
position ('click') (Fig. 8).
 Put the adapter in a wall socket and place the parent unit in the charger (Fig. 9).
The POWER light on the charger lights up.
,
5 Leave the parent unit in the charger until the batteries are fully charged
When charging for the first time or after a long period of disuse: switch off the
,
parent unit and let it charge continuously for at least 10 hours.
Charging normally takes 8 hours, but it takes longer when the parent unit is switched on
,
while charging. To keep the charging time as short as possible, switch off the parent unit
during charging.
The POWER light on the charger stays on, even when the batteries are fully charged.
,
When the batteries are fully charged, the parent unit can be used cordlessly for at least 
,
hours.
Note: The operating time of 24 hours is based on the assumption that the baby unit transmits 25% of
the time and is in standby mode for the rest of the time (when the baby does not make any sound).
Note: When the parent unit batteries are charged for the first time, the operating time is less than 24
hours. The batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the batteries are running low, the battery check light ( T) flashes red. Place the parent unit
in the charger.
Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent
unit is switched off.
mains operation
1 Make sure you have inserted the rechargeable batteries in the parent unit
 Put the adapter of the charger in the wall socket and place the parent unit in the
charger (Fig. 9).
The POWER light on the charger lights up.
,
using the appliance
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
 Press and hold the on/off button 3 on the baby unit for  seconds. (Fig. 11)
The nightlight lights up briefly.
,
The ON light lights up.
,
 Press and hold the on/off button 3 on the parent unit for  seconds. (Fig. 1)
The sound level lights light up blue briefly.
,
The battery check light ( T) lights up red briefly.
,
All manuals and user guides at all-guides.com