Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
BASIC FUNCTIONS
SWITCHING ON AND OFF
• Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE.
• The set is switched off when the POWER slider is in the
TAPE/OFF position and the buttons on the tape deck are
released.
– The volume, sound settings and tuner presets will be retained in
the set's memory.
ADJUSTING VOLUME AND SOUND
1. Turn the VOLUME/ SOUND CONTROL CENTER control
clockwise to increase or anti-clockwise to decrease volume on
the set (or press VOLUME 3 or 4 on the remote control).
™ Display shows the volume level indication
0-32.
2. To adjust the bass, mid and high frequency levels, press DIGITAL
EQUALIZER once or more until the desired option is displayed.
While the option is shown, turn the VOLUME/ SOUND
CONTROL CENTER control to increase or decrease
(- 5 to + 5 maximum) the desired frequency.
™ VOLUME can also be adjusted in this way with a level range
from 0-32.
3. Press DIGITAL DBB to switch dynamic bass boost on or off.
™ If on, the DIGITAL DBB light goes on.
4. Press INCREDIBLE SURROUND to switch the surround sound
effect on or off.
™ If on, the INCREDIBLE SURROUND light goes on.
Note: The effect of INCREDIBLE SURROUND may vary with
different types of music.
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
10
GENERAL INFORMATION
and a number from
VOL
+
•
•
•
•
0
•
•
•
•
–
Publicidad
