Descargar Imprimir esta página

Graco SnugRide Click Connect 30 Manual De Instrucciones página 30

Publicidad

Idiomas disponibles

Idiomas disponibles

6.3 Using LATCH to Install Base
1. MAKE SURE vehicle is on level ground. Make sure to check your
vehicle owner's manual for LATCH seating
positions.
2. For ease of installation, press button to extend
LATCH to its MAXIMUM LENGTH
3. Position base in vehicle seat as shown.
4. Make sure LATCH is through vehicle/LATCH
belt path normally used for vehicle seat belt.
Belt must lie flat and not be twisted.
5. Attach connectors to vehicle lower anchors.
Pull firmly on connectors to be sure they
are attached
6. Tighten LATCH by pushing down hard on
base and pulling the adjustment belt back
through belt path
.
.
.
.
30
CLICK!

Publicidad

loading