Descargar Imprimir esta página

GreenWorks Pro ED80L01 Manual Del Operador página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
Keep the trimmer head free of grass, leaves, or excessive
grease.
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SKID PLATE
1. Remove the screws with a Phillips Head screwdriver (not
included).
2. Replace with the new skid plate (1).
3. Tighten the screws.
10.4
REPLACE THE WHEEL
1. Remove the battery.
2. Remove the wing nut (1), washer (2), axle sleeve (3),
wheel (4), axle sleeve (3), rubber washer (5) and wheel
axle (6) orderly from the wheel assembly.
3. Replace with the new wheel.
4. Insert the wheel axle (6) through the slot (7) downward,
then put the rubber washer (5), axle sleeve (3), wheel (4),
axle sleeve (3), washer (2) and wing nut (1) orderly
through the wheel axle (6).
4
6
5
3
3
7
6
English
5. Tighten the wing nut (1).
11
TRANSPORTATION AND
STORAGE
1
Remove the battery pack from the machine before
transportation and storage.
11.1
MOVE THE MACHINE
When you move the machine, you must:
Stop the machine.
Remove the battery pack.
11.2
STORE THE MACHINE
Remove the battery pack from the machine.
Make sure that children cannot come near the machine.
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
2
Secure the machine during transportion to prevent
1
damage or injury. Clean and examine the machine for any
damage.
12
TROUBLESHOOTING
Problem
Possible Cause
The ma-
No electrical con-
chine does
tact between the
not start
machine and the
when you
battery pack.
push the
trigger.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
10
1
2
3
4
3
5
6
WARNING
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.

Publicidad

loading