Bycool blue line FLAT Instrucciones De Montaje página 25

FLAT
Fasten the fastening supports by tightening
12
the nut until the outer EPDM seal tightening
of the equipment is between 3 and 6mm.
Important: To avoid possible water leaks
into the inside of the cab the EPDM seal
tightening must be adjusted with the base of
the Bycool as indicated in the drawing.
3-6mm.
Cab roof
Tighten the nuts until the
seal tightening of the rubber
12
is between 3 and 6 mm.
Screw (4) M8 nuts to the support and (4) to
13
the base of the Bycool.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Air conditioning for vehicles
Base
Support
25
Check compression
thickness using a
tape
measure in the four
corners.
EPDM gasket
ES
EN
12
13