Publicidad
KNOW YOUR PRODUCT
See page 78.
1. Speed control
2.
3. Blade clamp
4. Adaptor
MAINTENANCE
WARNING
The product should never be connected to a power
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
WARNING
When servicing, use only original Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorised service centre
to avoid a safety hazard. Contact authorised service centre.
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised Ryobi service centre.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. We do not recommend using
the product for extended work on these types of materials.
2
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
LUBRICATION
All of the bearings in the product are lubricated with a
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety Alert
V
Volts
Hz
Hertz
Alternating current
W
Watts
n
No-load speed
o
Revolutions or reciprocations per minute
Class II tool
Double insulation
CE Conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Wood
Non-ferrous metals
Plastic
Drywall
Autogoods "130"
English
WARNING
Publicidad
