EN
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
11
FOLD AWAY THE HANDLE
1. Loosen the lower handle knobs (10) at both sides;
2. Push inward the lower handle ends to break free from the
brackets;
3. Fold down the handle for storage. Make sure the lower
handle holes engage with the lock pins (7)
12
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
7
10
Possible cause
Solution
The handle fasten-
Adjust the height
ers are not engag-
of the handle and
ed correctly.
make sure that the
fasteners are prop-
erly positioned.
The battery ca-
Charge the battery
pacity is low.
pack.
The bail switch is
Replace the bail
defective.
switch.
The battery key is
Put in the battery
not put in.
key.
English
Problem
The machine cuts
grass unevenly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
* If you cannot find the solution to these problems, go to the
service center.
13
TECHNICAL DATA
Voltage
40 V
Motor
Brushless
No load speed
3300 RPM
Deck size
19"
Front / Rear
7"
wheel size
Cutting height
7
options
12
Possible cause
Solution
The lawn is rough. Examine the mow-
ing area.
The blade height is
Move the wheels
not set correctly.
to a higher posi-
tion.
The grass is too
Increase the blade
tall, or the blade
height.
height is too low.
The blade is un-
Replace the blade.
balanced and
worn.
The motor shaft is
1. Stop the mo-
bent.
tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
The blade height is
Increase the blade
too low.
height.
The battery pack is
Charge the battery
out of power.
pack.
The build up of
Remove the bat-
grass clippings on
tery pack and
blade or deck.
check the deck or
blade if necessary.
(see General
Maintenance).
Operation temper-
Cool the machine.
ature of the ma-
chine is too high.