ENGLISH
* A plumbing permit and services of a licensed plumber may be required in some areas.
* The ice dispenser drain is gravity flow, so ensure drain hose has an adequate pitch or fall.
* Drain lines should not be installed directly to the sewer system. A vertical air gap of a minimum of 5
cm should be between the end of the drain hoses from the ice dispenser and the floor drain.
* Water should drain into an open trap.
* Be sure to use the new hose-sets supplied with the appliance. Do not reuse any old hose-sets.
1) By means of a suitable spanner or wrench, tighten the 1/2-3/4 nipple (accessory) into the Rc1/2 fitting on the rear of the ice
dispenser as indicated. P.T.F.E. tape and/or a suitable sealing compound should be used to obtain a leak free joint.
Note: Jointing compounds should be approved and suitable for potable water use.
2) Attach angled end of flexible inlet hose (accessory) to free end of 1/2-3/4 nipple ensuring rubber sealing washer is correctly
positioned. Hand tighten sufficiently to provide leak free joint.
3) Attach the other end of inlet hose to the water tap, noting washer is correctly positioned before hand tightening as above.
4) Attach grey flexible outlet hose (accessory) to the R3/4 fitting as indicated, confirming fitment of rubber washer before finally
hand tightening the joint. The hose can be cut to length as necessary to suit position of main drain.
Inlet Hose
Outlet Hose
II. OPERATING INSTRUCTIONS
All parts are factory-adjusted. Improper adjustments may result in failure.
If the unit is turned off, wait for at least 3 minutes before restarting the ice dispenser to prevent damage to the compressor.
This ice dispenser is designed to produce edible ice. To keep the ice dispenser hygienic:
* Keep the ice station clean. Clean it by using a neutral cleaner and rinse thoroughly.
1. START UP
1) Open the water tap.
2) Plug in the ice dispenser, and turn on the power switch to start operation.
Water Supply Inlet
Rc1/2
1/2-3/4 Nipple
Drain Outlet R3/4
NOTICE
HYGIENE
6
5cm air gap
Floor
Drain
Water Supply Tap
Inlet Hose