Maintenance; Scheduled Maintenance Table - KENT Razor Blade 26D Instrucciones De Uso

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working
conditions, which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be carried out with the machine off and the battery disconnected.
Moreover, before performing the maintenance, carefully read all the instructions in Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorized Service
Center.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual
that can be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Squeegee cleaning
Brush/cylindrical brush cleaning
Tank and vacuum grid with float cleaning
Battery charging
Squeegee blade check and replacement
Side skirt check
Solution filter cleaning
Battery (WET) fluid level check
Screw and nut tightening check
Check and adjustment of driving belts from motors to
cylindrical brushes
Squeegee cable sliding shoe lubrication
Electromagnetic brake efficiency check
Brush/pad-holder motor carbon brush check or
replacement
Vacuum system motor carbon brush check or
replacement
Drive system motor carbon brush check or
replacement
(1): After the first 8 working hours
(2): This maintenance procedure must be performed by a KENT authorized Service Center
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11
INSTRUCTIONS FOR USE
Daily or after using
Weekly
the machine
Every six months Yearly
(1)
(2)
(2)
(2)
(2)
(2)
(2)
13