BRUSH/PAD-HOLDER DECK OR
CYLINDRICAL BRUSH DECK
DISASSEMBLY/ASSEMBLY
NOTE
According to the following instructions, it is
possible to install on the machine either the
brush/pad-holder deck (1, Fig. K) or the
cylindrical brush deck (16).
To assemble/disassemble the deck it is not
necessary to remove the brushes/pad-holders.
Disassembly
1.
Drive the machine on a level floor.
2.
Lower the deck (4 or 5, Fig. C) by pressing the switch (4,
Fig. B).
3.
Turn the ignition key (12, Fig. B) to "0".
4.
(For brush/pad-holder deck) Disconnect the electrical
connector (3, Fig. K).
(For cylindrical brush deck) Remove the protection cover
(12, Fig. K) and disconnect the electrical connectors (3
and 11).
5.
Disconnect the solution supply hose (4, Fig. K).
6.
Remove the two cotter pins (6, Fig. K).
7.
Unscrew the knob (5, Fig. K) and remove the
brush/pad-holder deck (1) or the cylindrical brush deck
(13).
Assembly
8.
Assemble in the reverse order of disassembly.
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11
INSTRUCTIONS FOR USE
SAFETY FUNCTIONS
The machine is equipped with the following safety functions.
EMERGENCY STOP BUTTON
It is located in a position (2, Fig. B) that is easily accessible for
the operator. Press it in case of immediate necessity to stop
all machine functions.
To reset it, turn it clockwise.
SPEED REDUCTION
It reduces the machine speed in case of turns exceeding a
specified angle.
DRIVER'S SEAT MICROSWITCH
It is inside the driver's seat and it prevents machine
movement and brush rotation when the operator is not on the
seat.
ELECTROMAGNETIC BRAKE
Built-in the front wheel, it keeps the machine stopped when
the machine is off, when the emergency stop button is pushed
and when the forward gear pedal is not pressed.
17