Worx Sonicrafter WX668 Manual página 8

SAFETy INSTRuCTION FOR
CuTTINg
1. Hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden wiring
or its own cord. Cutting accessory
contacting a "live" wire may make
exposed metal parts of the power tool
"live" and could give the operator an
electric shock.
2. Always wear a dust mask.
SyMBOLS
WARNING–To reduce the risk of
injury, user must read instruction
manual
Warning
8
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
Before working with your tool make
sure that no power cords will be
damaged.
Avoid danger of injury from the
sharp edges of the accessories.
Accessories can become very hot
while working, presenting danger
of burns!
Oscillating tool
All manuals and user guides at all-guides.com
OPERATINg INSTRuCTIONS
INTENDED USE
The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster,
non-ferrous metals and fasteners (e.g. nails
and clamps) as well as for working on soft wall
tiles and for dry grinding of small surfaces. It is
especially suitable for working close to edges
and for flush cutting.
ASSEMBLy AND OPERATION
Mounting Accessories
Mounting The Sanding
Sheet
Mounting The Suction
Device (not supplied)
Operating The On/Off
Switch
Using the Variable
Speed Dial
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Make sure the tool is unplugged
prior to changing accessories.
Wear protective gloves
High oscillation frequency
Low oscillation frequency
NOTE: Before using the tool, read the
instruction book carefully.
Action
See Fig. A1-A3, B
See Fig. C
See Fig. D1-D5
See Fig. E
See Fig.F
Figure
EN