Publicidad
b). To cancel your changes, press [EXIT] and it will reset that menu item and bring you out of the menu entirely.
f. To exit out of the menu at any time, press the [EXIT] key.
g. All further examples and procedures in this manual will use the numerical menu short- cuts.
Appendix A. – Trouble shooting guide
Phenomena
You cannot turn on the radio.
During receiving, the voice is
weak or intermittent.
You cannot communicate with
other group members.
You hear unknown voices or
noise.
You are unable to hear anyone
because of too much noise
and hiss.
The radio keeps transmitting.
NOTE: If the above solutions cannot fix your problems, or you may have some other queries, please contact your dealer
for more technical support.
Analysis
The battery may be installed improperly.
The battery power may run out.
The battery may suffer from poor contact caused by dirty or damaged
battery contacts.
The battery voltage maybe low.
The volume level may be low.
The antenna maybe loose or maybe installed incorrectly.
The speaker maybe blocked.
The frequency or signaling type maybe inconsistent with that of other
members.
You may be too far away from other members.
You may be interrupted by radios using the same frequency.
The radio in analog mode maybe set with no signaling.
You may be too far away from other members.
You may be in an unfavorable position. For example, your
communication may be blocked by high buildings or blocked in an
underground area.
It may be the result of external disturbance (such as electromagnetic
interference).
VOX may be turned on or the headset is not installed in place
Remove and reattach the battery.
Recharge or replace the battery.
Clean the battery contacts or replace the battery.
Recharge or replace the battery.
Increase the volume.
Turnoff the radio, and then remove and reattach
the antenna.
Clean the surface of the speaker.
Verify that your TX/RX frequency and signaling
type are correct.
Move towards other members.
Change the frequency, or adjust the squelch level.
Request your dealer to set signaling for the
current channel to avoid interference
Move towards other members.
Move to an open and flat area, restart the radio,
and try again.
Stay away from equipment that may cause
interference.
Turn off the VOX function. Check that the
headphones are in place.
23
Solution
Publicidad
