Publicidad
Idiomas disponibles
Idiomas disponibles
This appliance must be grounded!
The appliance must connect to a current protection circuit or device at 50Amp or
less before being connected to power supply!
1. Remove the screw from the front of the unit to connect the power to the heater.
2. Attach the cable connectors to the unit (See Figure 6) and slide the
10- gauge wire through the cable connector.
NOTE: All wiring must be accordance to national and local electrical codes in the
United States. For certain applications conduit may be required See Figure6. Check
local electrical codes. If you run the wiring in conduit and wish to be able to turn the
heater be sure to purchase enough flexible conduit to allow the heater to be turned.
3. Connect the wire to the power block located in the base of the heater - See Figure 7.
4. Turn on the power at the main service.
CAUTION:
High temperatures – risk of fire. Keep flammable materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 ft. (0.9 m) from the front and top of the
heater and keep them away from the sides and rear.
To reduce the risk of fire, do not use it in areas where gasoline, paint or flammable
liquids are used or stored.
All manuals and user guides at all-guides.com
WARNING
WARNING
7
Publicidad
