Stopping the engine
NOTE
If engine does not stop, turn choke control knob anticlockwise to stop engine.
Return the unit to your authorized ECHO dealer to check and repair ignition switch before
starting the engine again.
1. Throttle trigger
2. Ignition switch
Release throttle trigger and allow engine to idle.
Place ignition switch in STOP position.
Checking chain tension
Make sure that the engine is shut off when checking chain tension.
NOTE
Always loosen clutch cover nut before turning the chain tension adjuster, otherwise the
clutch cover and tensioner will be damaged.
Chain tension should be checked frequently during work and corrected if necessary.
Tension the chain as tight as possible, but so it can still be pulled easily along the bar by
hand.
Chain lubrication test
Hold the chain just above a dry surface and open the throttle to half speed for 30
seconds.
A thin line of "thrown" oil should be seen on the dry surface.
Pre cutting test
Familiarize yourself with your chain saw before you start actual cutting.
For this purpose it may be wise to practice by cutting some small logs or limbs several
times.
Do not allow either people or animals into the work area.
Multiple operators - Keep a safe distance between two or more operators when working
together simultaneously.
20
WARNING