Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for choosing Philips AVENT
GB
The Philips AVENT Digital Bottle and Baby Food Warmer is the only warmer with advanced
Technology, designed to smartly and accurately adjust warming time based on contents and amount.
Whether warming milk or baby food that is frozen, chilled or at room temperature, the Digital Bottle
and Baby Food Warmer heats quickly, safely and evenly – with no hot spots. The versatile design holds
all AVENT Bottles, VIA Cups, and baby food jars or tins.
Please take 5 minutes to read through the ENTIRE INSTRUCTION LEAFLET including
the warnings before using your Digital Bottle and Baby Food Warmer for the first time.
PLEASE RETAIN THESE INSTRUCTIONS for future reference. Instructions are also
available at www.philips.com/AVENT.
Contents (A):
a. Lid
c. Warmer Base
b. Lid Flap – Lifts to accommodate
d. Lifter
larger bottles (330ml/11oz)
e. Interactive Electronic Display
Interactive Electronic Display Guide
Milk Mode
(in ANY container)
Baby Food Mode
(in ANY container)
Freezer Temperature Mode
(Select when warming
from frozen)
Fridge Temperature Mode
(Select when warming
from chilled)
Room Temperature Mode
(Select when warming
from room temperature)
N.B. Whilst pressing the Power/Mode Selection or Volume Selection/Start Button, please hold the warmer base to prevent
the warmer from slipping.
Instructions for Use
1. Ensure that the warmer is placed on a firm level surface. Open the lid using the front catch, and fill
the warmer with the appropriate amount of water (i) – See page 2 to determine water amount.
Place the fully assembled bottle (including dome cap to prevent overheating) or storage container
with lid in the warmer. For food jars and tins, please refer to manufacturer's instructions.
N.B. When warming a 330ml/11oz bottle, the lid flap will lift to accommodate the larger size.
This will cause a small amount of steam to rise from the warmer.
Close the lid ensuring that the front catch 'clicks' shut.
2. Plug in the warmer and switch on at the mains.
3. Switch on the warmer by holding the Power/Mode Selection Button for 3 seconds (ii). The
warmer will beep, and the milk, room temperature and ml/oz symbols will illuminate. It is now
ready for use. If the lid has not been closed correctly, the symbols will flash. When the unit is
switched on, it automatically defaults to the milk/room temperature mode. If this is the mode
you need, go to step 5. If not, proceed to step 4.
4. Choose milk or food, and select the starting temperature (iii) by pressing the Power/Mode
Selection Button repeatedly until the desired symbols are illuminated.
Please note that there are 6 possible options: milk from room temperature, milk from chilled,
All manuals and user guides at all-guides.com
Power/Mode Selection Button –
Hold button for 3 seconds to switch
the warmer on/off. Press repeatedly
to select milk or baby food and
starting temperature.
Volume Selection/Start Button –
Press repeatedly to select the volume
310
11
of milk or food. Once desired
285
10
selections are made, hold button for
255
9
230
8
3 seconds to start warming cycle.
200
7
170
6
140
5
Volume Display –
115
4
Displays the selected amount of liquid
85
3
55
2
or food in both ml and oz
30
1
milk from frozen, food from room temperature, food from chilled, and food from frozen. (See
Display Guide if needed.)
N.B. Warming food jars or tins from frozen is NOT recommended. However, you can warm
frozen food in VIA Cups within the warmer.
N.B. Please ensure that the correct options are selected, as milk and food should not be heated
for too long.
5. Select the amount of milk or food in the bottle or container by repeatedly pressing the Volume
Selection/Start Button until the desired volume is illuminated (iv). If the desired amount is not
shown on the display, please select the amount nearest to it.
N.B. For volumes in grams, select the same amount in ml (e.g. for 85g select 85ml).
N.B. The maximum volume that may be selected when warming food from frozen is 230ml/8oz.
6. Start the warming cycle (v): Once the desired settings are illuminated, hold down the Volume
Selection/Start Button until the warmer beeps. The volume display will now flash ascending and
descending lights up to the selected amount.
The warming cycle is in progress – Do not open the lid.
7. Completion of warming cycle (vi): When the cycle is complete, the warmer will beep intermittently
for 30 seconds and all the volume display lights will continuously flash for 3 minutes. You can
remove the contents as soon as the warmer begins beeping. After 3 minutes, the warmer will
beep 5 times and will turn off automatically.
N.B. Philips AVENT recommends removing and using the contents immediately when the
warming cycle is complete, even before the warmer automatically turns off.
8. Open the lid carefully to avoid any residual steam. Be careful when opening the lid as steam can
escape and cause injury. Use a cloth when removing the container, as it may be hot (vii). Use
the lifter to raise small bottles, VIA Cups, small food jars or tins. Pull the lifter just above the
circular rim. Rest the lifter on the rim where it naturally sits.
N.B. Do not remove the lifter from the warmer.
9. Before feeding your baby: Always check feed temperature before feeding
(a) Milk – shake the bottle or milk storage container and check the temperature of the milk
by sprinkling a few drops on the back of your hand.
(b) Food – stir the food thoroughly and test it yourself with a spoon to ensure it is not too hot.
If food is not warm enough, consult the Troubleshooting Guide.
N.B. Please ensure the lid of the container is tightly secured prior to shaking.
10. Unplug at the mains, and empty any residual water (viii). Ensure that the plug does not come
into contact with water. If warming an additional bottle or container, continue from step 1.
Otherwise, clean the inside and outside of the warmer with a damp cloth (viii). To remove the
lifter for cleaning purposes ONLY, lift vertically up until it naturally resists. Push the handle away
from you and rotate 90º or until it can naturally be removed, then lift out.
N.B. For microbiological and hygienic reasons, once heated, milk and food should not be
reheated again, and should be discarded if not used immediately. Please consult your health
professional/breastfeeding adviser for further guidance about safety recommendations on feeding.
N.B. If at any time the warmer is switched on and not running a cycle, it will automatically turn
off after 3 minutes if no selections have been made.
Approximate Warming Times
Milk 115ml/4oz from room temperature
Milk 115ml/4oz from chilled
Milk 255ml/9oz from room temperature
Milk 255ml/9oz from chilled
Food 230ml/8oz from room temperature
Food 230ml/8oz from chilled
2 mins
3 mins
3 mins
4.5 mins
5 mins
7 mins
Publicidad
