Cardin FM400 OC2 Instrucciones De Uso Y De Programación página 20

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
GB
ROLLING-CODE SYSTEM
The FM400 and NOIRE series have rolling-code systems. This provides an
extremely high level of security, since there is no risk of cloning of the code
transmitted.
CAUTION! In the NOIRE series, the Rolling-Code function can be disabled
by removing the jumper JP1.
RECOMMENDATIONS
- Before doing any wiring or modifications to the connections, cut the power
supply.
- Non-observance of the above instructions could adversely affect the proper
operation of the device.
Cardin elettronica S.p.A disclaims all responsibility for any malfunctions
and/or damage caused by failure to observe the above instructions.
TRANSMITTER PROGRAMMING
The following description covers the procedures for memorizing transmitters
directly in the receiver; for programming with PRG, refer to the relative manuals.
OC2 receivers have two outputs and a number of options, with the following rules:
- the same code cannot be programmed on more than one channel of the same
receiver.
- only pulse operating mode is enabled in output (1).
- the code memorized activates one function of the circuit board connected. For
operation and options, refer to the control unit manual.
- during programming, keep the transmitter and receiver about 50 cm apart.
- all the codes programmed in a receiver are stored in the memory chip (M, fig. 1).
If the memory chip is moved to another receiver (of the same series), the entire
programming is retained.
Self-learning of codes for operation of output 1
This output is usually combined with the control unit's Step/Step control.
- Press button P1 (fig.1) quickly on the receiver.
- LED L1 blinks 5 times.
- During the blinks, press the key of the code to be memorized on the transmitter.
20

Publicidad

Tabla de contenido
loading

Productos relacionados para Cardin FM400 OC2

Este manual también es adecuado para:

Noire oc2Edge oc2Tango oc2 sw

Tabla de contenido