Magnat MONITOR SUPREME 2002 Manual De Instrucciones página 7

Dear MAGNAT Customer,
Congratulations on your fine new loudspeakers and thank you very much for choosing MAGNAT! You
have made an excellent choice. The high-quality speakers produced by MAGNAT are renowned all over
the world.
Please study the instructions and information below carefully before using your new loudspeakers.
GENERAL INFORMATION ABOUT CONNECTING YOUR MAGNAT MONITOR SUPREME
LOUDSPEAKERS
Please always use a good quality loudspeaker connection cable from an audio dealer. To prevent
impairment of sound quality, we recommend cables with cross-sections of at least 2.5 mm² for lengths up
to 3 m and at least 4 mm² for lengths above 3 m.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables. Place the
loudspeakers in their planned positions and cut the cables to the right length. The cables for both channels
should always be exactly the same length.
Strip 10 – 15 mm of insulation from the ends of the cables. Twist the ends – this is much better than tinning
them with solder – insert them in the terminals and tighten the terminal screws firmly.
For good sound it is imperative that the cables must be connected in such a way that the speakers are
"in phase". This means that the black negative terminals on the speakers (-) must be connected to the
negative (-) terminals on the amplifier, the red positive (+) speaker terminals to the positive (+) amplifier
terminals. To make this easier one wire of most speaker cables is marked with a coloured strip or a ridge
in the insulation.
Before switching on the system double-check all your connections and make sure that the terminal screws
are tight and that there are no short circuits caused by stray wire filaments – this could cause serious
damage to your amplifier!
THE MAGNAT MONITOR SUPREME LOUDSPEAKERS IN STEREO MODE
In the ideal configuration the speakers and the listening position should form an equilateral triangle. When
the left and right speakers are the same distance from the listening position their sound arrives at the same
time, resulting in a harmonious, natural music reproduction. (Fig. 1)
There should be a clear line of sight between the loudspeakers and the listening position. Any sound-
absorbing or reflecting obstacles in the path will distort the sound. When you install the loudspeakers the
following distances should be maintained:
Monitor Supreme tower loudspeakers: at least 20 cm away from the rear wall and at least 30 cm from
the side walls. This will prevent excessive emphasis of the bass range.
Monitor Supreme 202, 102: shelf loudspeakers should also be as free-standing as possible, the distance
to the sides and rear to walls and items should be at least 10 cm, the tweeters should be located at ear
height.
Monitor Supreme 2002, 1002 and 802 spikes: you should use the supplied spikes when setting the
speakers up. This isolates them from the supporting surface, preventing unpleasant resonance effects.
The spikes are screwed into the threaded bushes on the bottom of the speaker.
MAGNAT MONITOR SUPREME LOUDSPEAKERS AS A FRONT OR REAR LOUD-SPEAKER
The front loudspeakers are positioned at ear height on the left and right as equidistant from the television
as possible. The rear loudspeakers are placed at ear height or a little above on the left and right besides
or better behind the listening position. (Fig. 2)
7