Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE AIR CONDITIONER
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing
outdoor conditions.
Control Panel Lights On/Off Feature
This air conditioner has a control panel lights on/off feature
where its lights will turn off when there is no activity with the
controls for over one minute. To wake up the controls, press
any pad on the controls and the lights will come on to show
the previous settings.
Remote Control
• To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
• The remote control signal has a range of up to 20 feet.
Cool Mode
Use the Cool mode at Low, Med, High or Speed for cooling.
Use the Temperature Increase / Decrease pads to
set the desired temperature between 64°F and 86°F in 1°F
increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off to keep
the room at the set level of comfort. Set the thermostat at a
lower number and the indoor air will become cooler. Set the
thermostat at a higher number and the indoor air will become
warmer.
Eco Mode
Controls the fan.
ON—The fan will cycle on and off with the compressor. This
may result in wider variations of room temperature and
humidity. NOTE: the fan may continue to run for a short time
or may pulse intermittently after the compressor cycles off to
sample the room air.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed to
provide air circulation and filtering without cooling. Since
fan-only settings do not provide cooling, a Set temperature
cannot be entered. The room temperature will appear in the
display.
Auto Fan Mode
Set to Auto for the fan speed to automatically set to the
speed needed to provide optimum comfort settings with the
set temperature.
6
It must not be used when the outdoor temperature is below
freezing (32°F).
To turn this feature off, press and hold the SLEEP pad,
on the unit, for 5 seconds. The unit will beep to signal the
successful toggle of the feature on and off.
• Make sure nothing is between the air conditioner and the
remote control that could block the signal.
• Make sure batteries are fresh and installed correctly as
indicated on the remote control.
NOTE:
while set to a Cool setting or if turned from a fan setting to
a Cool setting, it may take approximately 3 minutes for the
compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
OFF—The fan runs all the time, while the compressor cycles
on and off.
If the room needs more cooling, the fan speed will
automatically increase. If the room needs less cooling, the fan
speed will automatically decrease.
49-5000567 Rev. 0
Publicidad
