Switching Off; Operating Environment - Pooxtra Pure Sine Wave Serie Manual De Usuario

SWITCHING ON AND SWITCHING OFF ON LOAD
Please ensure that the following procedure is used for switching on and switching
off the inverter when a load is already connected to the inverter:
Switching on
1. Switch off the load connected to the inverter
2. Switch on the inverter
3. Wait for a few seconds
4. Switch on the load

Switching off

1. Switch off the load connected to the inverter
2. Switch off the inverter
CONNECTING LOADS
1. Make sure that the single load or the combined load requirement of your
equipment does not exceed theinverter's output rating.
2. Switch off the inverter
3. Switch off the load
4. Plug the cord(s) from the load(s) into the AC receptacle(s) of the inverter
5. Switch on the inverter. Wait for a few seconds
6. The LED display will be working to indicate that the inverter is functioning
7. Switch on the load(s)
The inverter is engineered to be connected directly to standard electrical and
electronic equipment in the manner described above. Do not connect the power
inverter to household or RV AC distribution wiring. Do not connect the power
inverter to any AC load circuit in which the Neutral conductor is connected to
Ground (Earth) or to the Negative of the DC (battery) source.
WARNING: Do not connect directly to AC distribution wiring. This inverter is
NOT grid interactive.

OPERATING ENVIRONMENT

For best operating results, the inverter should be placed on flat surface, such as the
ground, car floor, or other solid surface. The power cord allows easy positioning of the
inverter. The inverter should only be used in locations that meet the following criteria:
DRY
Do not allow water and/or other liquids to come into contact with the power inverter.
In all marine applications, do not install the inverter below or near the waterline and
keep the inverter away from moisture or water.
COOL
Ambient air temperature should be between 30 degrees F (-1 degree C) non-
condensing, and 105 degrees F (40degrees C). Do not place the inverter on or near
a heating vent or any piece of equipment which is generating heat above room
temperature. Keep the inverter away from direct sunlight, if at all possible.
www.pooxtra-inverter.com
TM
13