Tennant V-HDU-14 Manual Del Operario página 7

3. Pull and turn quick-release hook to remove power
cord (Figure 6).
FIG. 6
4. Plug power cord into a grounded wall outlet (Figure
7).
Grounded Outlet
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 7
FOR SAFETY: Do not operate machine unless cord
is properly grounded.
FOR SAFETY: Do not operate machine with the use
of an extension cord.
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Activate ON/OFF switch.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
2. Lower handle to operating position by stepping on
handle release latch (Figure 8).
NOTE: Brush motor will not start until handle is lowered.
V- -HDU- -14 / V- -HDU- -36 (04- -10)
Grounding
Edge/hole
(220V/230V/240V)
Home Find... Go To..
FIG. 8
3. Begin vacuuming floor. Operate machine with a
back and forth motion or "W" pattern.
4. To operate in the horizontal position, lower handle
to the stop point and step on release latch again
(Figure 9).
Upright
Position
FIG. 9
5. To stop vacuuming, raise handle to the upright
position and turn off power switch.
OPERATION
EN
Operating
Position
Horizontal
Position
7