ims PRO 25 K Manual De Instrucciones página 20

6 - CURRENT SETTING (FIG-2)
Use the adjuster to set the current relative to the thickness and type of the metal sheet. Adjusting the pressure at maximum power should cover
all other normal cutting situations.
7 - STARTING THE CUTTING MODE (FIG-2)
The PLASMA cutting machine is equipped with pilot arc system. This system allows starting the arc without touching the piece to cut. You have 2
ways to cut your piece :
▪ Press the trigger > pilot arc formation > cutting by contact with the piece.
▪ Contact with the piece > press on the trigger > immediate cutting
▪ During the cutting, make sure to maintain the contact between the nozzle and the piece to cut.
SAFETY TRIGGER
The torch is equipped with a safety latch to prevent accidental use: Unlock it and pull the trigger as below:
Wear appropriate protective equipment. Stay away from the tip of the torch. Keep your hands away from the cutting trajectory. Never
point the torch towards you or another person.
TIPS FOR CUTTING
• Lightly drag the tip on the part for an even cut. This will guarantee a constant, adapted distance.
• When cutting, ensure that the sparks come from the bottom of the part . The sparks should lag slightly behind the torch when cutting (angle of
15 ° to 30 ° from the vertical).
• If the sparks fly from the top of the part, slow the movement, or set the output current to a higher level.
• For straight cuts, use a ruler as a guide.
MANUAL CUT FROM THE EDGE OF THE PART
With the earth clamp is fastened to the part, maintain the torch's tip perpendicu-
1
larly (90°) to the edge of the part.
Press the torch's trigger to start the arc until this one has completely cut into the
2
part.
Once the part is cut, slightly drag the tip on the part to continue the cut. Try to
3
maintain a regular rythmn.
20
PLASMA CUTTER 25 K / 35 KF / 30 FV
1 2 3
EN