Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk 3707 Manual De Instrucciones

3707 - 3707/10 - 3907 - 3907W - 3907/18

Packing and unpacking

All the dispatched equipment has been thoroughly checked
before being delivered to the haulage contractor.
On arrival, check the machine to see that it has not been
damaged during transport. If this is the case, immediately
lodge a complaint with the haulage contractor.
Dispose of the packing materials in compliance with the laws
in force.
Model A (mm)
3707
3707 C
3707/10
3707/10 C
3907
3907 C
3907W
3907W C
3907/18
3907/18 C
(*) Weight with packing

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the machine is placed
on must be suitable for bearing its weight.
If the device is to work in a fixed position, allow wide space
around the device in order to ensure freedom of the movement
and allow the maintenance staff to operate with ease.
The manufacturer shall not be liable for any damages
caused to the machine during lifting, when the lifting
GB
equipment supplied by the manufacturer is not used.
E
E
C65
Figure 3
B (mm) C (mm)
1,700 900 1,950
1,700 900 2,300
1,700 900 1,950
1,700 900 2,300
1,700 900 1,950
1,700 900 2,300
1,700 900 1,950
1,700 900 2,300
1,700 900 1,950
1,700 900 2300
CAUTION!
Setting to work - connection to the power
supply
■ Make sure there is no evident sign of damage to
the machine before starting work.
■
Before plugging the machine into the electrical
mains, make sure the voltage rating indicated on
the data plate corresponds to that of the electrical
mains.
kg (*)
■ Connect the plug into a socket with a correctly
installed ground contact/connection. Make sure
319
that the machine is turned off.
■ The plugs and connectors of the connection cables
340
must be protected against splashes of water.
333
■
Check that for proper connection to the electrical
mains.
350
■ Use the machine only when the cables that connect
338
to the electricity mains are in perfect condition
(damaged cables could lead to electric shocks!).
360
■
Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
352
cable.
370
380
400
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the cable).
■ Only replace the electric power cable with one of
the same type as the original: H07 RN-F, The same
rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
The system safety officers must:
■ Prevent any improper use or manoeuvre;
■ Make sure that the safety devices are not removed or
tampered with;
■ Check that all maintenance operations are regularly
performed;
■ Make sure that no machine part (couplings, holes, etc.) is
modified to attach additional devices;
■ Make sure that only original Nilfisk spare parts are used.
The user shall be responsible for ensuring that installation
complies with the all relevant local provisions. The
equipment must be installed by qualified technicians who
have read and understood the instructions herein.
6
CAUTION!
CAUTION!
NOTE