Residual Risks; Maintenance - ELLECI Max Serie Manual De Uso Y Mantenimiento

EN

18. Residual risks

The residual risks associated with the machine are minimized by the manufacturing standards such as the safety voltage (24 Vdc) in use on the machine
and the correct operation of the grounding system which guarantee the safe use of the Max 1000/900. Nevertheless, the following situations can
occur due to incorrect use of the product:
N.
Spilling of liquids on the floor that can render the treading surface slippery due to improper filling of the wash basins and of the
1
devices, caused by arbitrary acts of the technician.
2
Collapse of the structures and drawer guides due to excess loading
3
Risk of electrocution due to erroneous connection of the power cord connected to the 230 Vac voltage socket
4
Risk of projection of objects due to the introduction of solids in the food waste disposer
5
Malfunctioning of the oil aspirator pump due to prolonged use without oil
Residual risks are reduced if the instructions and the guidelines contained in this manual are followed strictly.

19. Maintenance

PROBLEMS, DEFECTS
The following is a list of the possible defects that can appear, their causes and the proposed countermeasures for resolving them:
Problem
The Max 1000/900 does not per-
form any function
The indication light (LED) next to
the main switch is flashing
The SIR does not work
The ultra sonic wash basin does
not work
The water replenishment of the
ultrasonic wash basin does not
work
The drainage of the ultrasonic
wash basin does not work
The oil aspirator does not work
The food waste disposer does not
work
38
Cause
The main switch is in the 'off' position-
the indication light (LED) is off
Electricity is not flowing
Electricity is not flowing
Check the BLOCK 1 function
Failure of the control panel
Check the BLOCK 1 function
Failure of the control panel
Check the BLOCK 1 function
Failure of the control panel
Check the BLOCK 1 function
Failure of the control panel
Check the BLOCK 1 function
Failure of the control panel
Check the BLOCK 1 function
The thermal safety device has intervened
Failure of the control panel
Residual Risks
Check the position of the main switch on the front panel
Check the presence of electric current
The system is in battery mode, it will automatically adjust when elec-
tricity is restored.
Check the BLOCK 1 function
Failure of the control panel
Perform the release maneuvers
Contact the technical assistance center
Perform the release maneuvers
Contact the technical assistance center
Perform the release maneuvers
Contact the technical assistance center
Perform the release maneuvers
Contact the technical assistance center
Perform the release maneuvers
Restore the thermal circuit breaker located on the back of the device
If the attempt proves negative - Contact the technical assistance center
Contact the assistance center
Solution