CASO DESIGN TC 2100 Thermo Control Manual Del Usuario página 46

• When the desired set-point temperature is reached, the heat supply is stopped and the
display shows "END".
• In addition you can control the cooking time with the timer:
a) If the desired core temperature is reached but the programmed time has not yet
expired, then the heat supply will be stopped and the display shows "END".
b) If the programmed time is reached, but the desired core temperature was not yet
reached, then the device switches off automatically.
• You can switch to power mode with button Level or to direct functions with button
Function, to start the cooking process.
• Please note that the two functions of level and temperature can be chosen as
alternative. You can either work with the power levels or with the temperature stages.
The most recently selected function is active.
Please note
► In case of grilling or cooking deep fry food we would advise you to use the function
"Temperature" as in this case you can use temperatures up to 240°C.
15.4.4 Timer
• Press button Timer, then use +/- buttons to set the operating time from 1-180 minutes
in 1-minute intervals. Once the time is up, an acoustic signal sounds and the device
automatically goes into standby mode.
Please note
► During timer operation, you can change the duration at any time with the +/- keys. With
the memory function of the device, the power stage or temperature settings remain
unchanged here.
15.4.5 Direct functions
Switch on the device with On/Standby and choose with button Function the desired direct
function. The corresponding lamp will light up.
Preset Direct functions
Direct function
Heat I
Heat II
Boil
Fry
With button Timer you can select the operating time with the +/- keys.
Setting
Level 1
Level 2
Level 8
Level 10
46