Impecca PowerIt CJK-841 Manual De Usuario página 3

Arrancador portátil
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHECKING UNIT CHARGE
Press the charge indicator button on the side of the unit. LEDs will illuminate to indicate
the unit charge; no lit LEDs indicates that your unit must be recharged before use.
UNIT CHARGE LEVEL BASED ON LED INDICATORS:
No LEDs illuminate: unit battery drained - recharge immediately!
1 LED: 25% charge
2 LEDs: 50% charge
3 LEDs: 75% charge
4 LEDs: 100% charge
JUMP-STARTER OPERATING INSTRUCTIONS
IMPORTANT: Read these instructions carefully before each use of the jump-starter
functionality. Ignoring these instructions could lead to physical injury, bodily harm,
or even death as well as damage to vehicles or other objects.
Press the unit power on button; at least 2 LEDs should illuminate before attempt-
ing to jump-start a vehicle.
Connect the RED clamp to the vehicle's positive (+) battery terminal.
Connect the BLACK clamp to the vehicle's negative (-) battery terminal.
Firmly insert the blue end of the jumper cable into the jump-start socket of the
battery unit.
Turn the vehicle ignition switch and start the vehicle. Leave the vehicle running to
continue charging the vehicle's battery.
When the vehicle is started, disconnect the blue end of the jumper cable from the
battery unit.
Disconnect the red and black clamps from the vehicle battery terminals.
CHARGING OTHER DEVICES
After connecting auxiliary power cables, press the power on button to begin charging.
USB-POWERED DEVICES
Plug a USB cable or use the provided adapter cable to the right—side USB 5V 2.1A output
port. The left USB port is capable of powering smaller devices.
Note: certain tablets, large phones, and other devices may not be able to draw sufficient
power from the USB port to charge while in use. See your device manual for minimum
charging specifications.
–3–

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Powerit cjk-1241

Tabla de contenido