Publicidad
1. Re-install the inner panel using 2 screws removed in first step.
2. Re-install panel by aligning all 4 screws protruding from panel through
the keyhole shapes on stand. Note: Outer panel may be secured
in place by tightening the fasteners on the backside of the panel.
1
Operation: Remote Control
• Hold down the "down" button to initialize unit.
• Up button will raise display to presentation mode
• Down button will lower display to transport mode.
Troubleshooting
• Double check that power cord is firmly plugged into power supply
•
Hold down the "down" button continuously for several seconds to reset unit
• More troubleshooting and repair information found on page four of this manual
Salamander Designs - Electric Lift Wall Display Stands 75"
2
www.salamandercommercial.com
501-674 [6.22]
page 9 of 24
Publicidad
