Dyna-Glo DG9WB Manual página 5

ASSEMBLY INSTRUCTIONS
NOTE: The motor bracket (J) can be adjusted to accommodate most attachment points (see Figure 1).
Review the various adjustment methods (shown in Figures 2 through 7) to determine the correct fit for
your grill before attaching. Some grills have a spit rod slot on the firebox and it is possible that the spit
rod bracket (H) might not fit your grill. If this is the case, slide the collar (E) onto the spit rod (B). Allow
the groove in the collar (E) to rest in the slot opening, as shown in Figure 8.
Fig. 1
Fig. 8
J
NOTE: On some grills the spit rod (B) may not be long enough. Attach the spit rod extender (I) and
proceed with installation.
1
J
AA
2
A
J
This side up
J
J
E
B
1. Attach motor bracket (J) to outer left or right side of the firebox
CC
BB
H
2. Slide rotisserie motor (A) over motor bracket (J). The rotisserie
This side up
Fig. 2 Fig. 2
Fig. 5
H
using two bolts (AA), two washers (CC) and two nuts (BB).
Allow enough clearance for spit rod. Note the attachment
holes used for motor bracket (J) and repeat for spit rod bracket
(H) for opposite side using two bolts (AA), two washers (CC)
and two nuts (BB).
Hardware Used
Bolt
AA
Nut
BB
CC Washer
motor (A) can be mounted one of two ways, depending on the
desired height of the spit rod (B).
5
Fig. 3 Fig. 4
Fig. 6
Fig. 7
x 4
x 4
x 4