HEBU medical GOLD II Accu Instrucciones Para El Uso Y El Servicio página 23

Oscillo-Saw GOLD II Accu
4. Screw the retaining screw in manually until hand tight.
5. Then tighten firmly using the fork wrench, as described above. The tightening torque is
6 - 7 Nm. Caution! Do not overtighten.
7 Operation
Switching on and off (see
Switching on: Push the switch forwards ( I )
Switching off: Push the switch back ( 0 )
Setting the oscillating
frequency (see )
fig. 6
Select the oscillating frequency
when the motor is running. The
optimum oscillating
can be selected at the speed
gauge depending
properties of the plaster cast.
Oscillating
preselection using the electronic
speed gauge.
Lowest oscillating frequency
Highest oscillating frequency
fig. 4 Inserting the saw blade
)
fig. 5
frequency
on the
frequency
( 1 )
( 6 )
fig. 5 Switching on and off
fig. 6 Setting the oscillating frequency
EN
23